The 3rd generation center-feed actions can be fit to our 2nd generation stocks with minor alterations. The gap of the front of the mag well will need to be “blocked” (front to back) to hold the steel magazine frame in the correct position. There will need to be a flat spot inlet to accept the rear l-shaped tab, with attention to the depth as this is a bearing surface for the action. On short action 3rd generations the front escutcheon hole needs to be enlarged so screw hole location can be moved forward approx. a 1/16th of an inch. Woodworking gunsmithing experience is suggested when converting to the 3rd generation guns.