The Ross FT's design is a synthesis of design elements requested by you the customer for a thumbhole design. With a large rollover cheek piece for scope usage and straight comb design to minimize cheek slap when shooting, the hand conforming thumbhole allows for increased accuracy while distributing the recoil among the palm and shoulder thus minimizing muzzle jump and felt recoil. The forend is proportioned to complement barrels from 21 inches to 25 inches in length nicely and will accommodate barreled actions with Standard sporter contour barrels, and larger barrels up to a tapered varmint design can be inlet in these stocks.
The Ross FT's are available in a wide range of inlettings to accommodate most barreled actions.
It must be noted that due to the variations among models and tolerances that factories may or may not routinely adhere to, some minor fitting may be required, even on our fully finished drop in parts, to achieve that perfect fit to your action. Although seldom, you must be willing to make these changes if necessary.
Please read through the READ PRIOR TO ORDERING information to confirm the stock you are ordering is the correct one for your firearm.
Please Note: Our Winchester Model 70 stock is made for the POST-64 Model 70 with the Hinged Floor Plate.
All early Winchester Model 70 POST-64 actions were based on the long action receiver measuring 7 5/8". Production of the short action receiver started in 1984-85 measuring 7 1/8". Please check center to center on your trigger guard screws to insure proper stock is being ordered.
|
Short Action = 7 1/8" |
Long Action = 7 5/8" |
