Sks Yugo 59/66 Handguard

SKS YUGO 59/66 HANDGUARD

It is your responsibility to confirm the dimensions of your firearm with the supplied dimensions of our part.

• Barrel Channel at Rear: 11/16"
• Barrel Channel at Front: 11/16"
• Receiver Edge to Center of Mounting Screw: N/A
• Over All Length of Part: 5 5/8"

ATTENTION CUSTOMERS: This inlet was developed using a Yugo Model 59/66 with a blade style bayonet. It is our understanding that this inlet will work for most, if not all, SKS model variations with minor fitting. (e.g. The Albanian SKS will not fit.) Installation of the hand guard will require removal of the hand guard ferrule. You are urged to research the "how" to replace a hand guard prior to ordering. The removal of the ferrule is not a difficult task, but the ferrule can be easily damaged during the process if proper care is not exercised. Finding a replacement ferrule may prove to be a challenging task if it is damaged beyond repair during removal and or installation. You will need the ferrule and the ferrule pin from the original forend.

All finished parts have been CNC inlet to Boyds' House Action. Variations may exist from firearm to firearm, minor fitting may be required to get that perfect fit to your firearm.

Natural cosmetic imperfections such as minor knots, burls, heartwood, mineral lines or minor cosmetic fill work are not considered a defect.